Dialogic D120JCTLSEW card - Driver config and GC demo config : help needed

Hi,

I am trying to run GC demo application and need help for configuring demo app and driver.

I have Dialogic card D120JCTLSEW connected to the PCIe on dell server. I have installed linux Dialogic driver 6.1.

Can I run GC demo app without anything connected to Dialogic board in loopback mode?

How do I make sure drivers are properly loaded?

While running "listboards" command I get error "Failed to open driver message queue, Driver failed to initialize" and "devmapdump" command shows Dialogic card connected to slot/bus 0/65.

How do I resolve this? or can you guide the steps to follow to configure drivers and run GC demo app in loopback mode?

Thank you,

Kush.